• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Another UTH problem....

bataco

bataco

Daniel
It only covers 1/4 of my viv, It's pasted vertically and If I paste it the horizontal way it would leave unheated zones... this way heats completely 1/4, it's not good right?
 
DSC03183.jpg
 
If your UTH covers 1/4 of the viv... that's more than enough! Your snake needs a warm zone and a cool zone. Place a hide on each end of the viv so your snake can regulate its body temps. LOL
 
bataco said:
1/4 is ok? god that's great! I thought it had to be 1/3
Click to expand...
They say 1/4 to 1/3, but what you have is fine. Just make sure that one hide is right over it, another on the far end, and some places to hang out in peace in between. I had a small one like that, but did it vertically and the mistake I made was misjudging where the thing was after I covered it in aspen, and the hide was too far off. The way you have it would have been smarter.
 
oh perfect because I had it the other way haha, yeah I placed a hide in there, I think the temp is regulating now with the zoo med rheostat =S I just have to wait to see
 
You must log in or register to reply here.
Back
Top