• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Mounting Thermometer On Rack

Nanci

Nanci

Alien Lover
So when I was changing waters today I got tired of the thermostat tipping over behind Inez's bin when I pulled the bin out. I'd mounted the Herpstat by unscrewing one of the rack's screws just enough to hang it, but the head of the screw is too big for the slot in the back of my thermometer. So I made a hanger by bending a small nail with a pliers and a needle nose pliers.
 

Attachments

  • Rack 015.jpg
    Rack 015.jpg
    261.9 KB · Views: 16
How it looks hung up: (The wires need slack so I can slide the bins in and out. The top reading is directly over the heat cable, inside, and the bottom reading is a few inches into the warm hide, under the aspen. I just changed the setting, raised it two degrees, [96F- yikes!] and it is stabilizing).
 

Attachments

  • Rack 014.jpg
    Rack 014.jpg
    267.7 KB · Views: 15
And I finally got around to printing cage cards off Degei. I think they look nice.
 

Attachments

  • Rack 016.jpg
    Rack 016.jpg
    253.2 KB · Views: 15
You must log in or register to reply here.
Back
Top