• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Been 6 weeks already! + egg denting question

bekers71

bekers71

What addiction?!
Well here are the "Beast" eggs. They are looking pretty good so far and have gotten pretty big. They are in a 6qt container if they helps put their size in perspective. 12 all together but the one on the bottom of the big pile doesn't look so good.

Here's the question. Last night when I went to check on them one egg had a dent about 1/2 long on the side. After the lid was off for a minute, the dent was gone. What could cause this to happen? The tote humidity stays around 80%, give or take a little.

P1060812.JPG

Just a reminder which parents the beast are. LOL
P1040998.JPG
 
Usually, denting is caused by low, or lower than ideal, humidity.
However, eggs can have some denting just prior to hatching (which is something normal).
 
You must log in or register to reply here.
Back
Top