• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Snakes got new tubs...

HoosierHerper

HoosierHerper

Josh
Josh,
I really like these 15 Qt clip on tubs by Sterlite. I have a whole bunch, think i bought the store out. They were marked down to $3 where I am at. So I loaded up on them. I may be more this weekend.
 
Lol...There were $4 a piece here, and it was that or the "plain-jane" 12 qts...and I like the little bit of extra floor space w/the 15qt.
 
Ya I didn't want to have to buy bungees too...even though it was all cheap, including the mouse stuff...I didn't mean to spend that much :D Lol...less than $50 for EVERYTHING....soldering iron, velcro, tubs for snakes, and all the stuff for the mice...
 
Lovely tubs...my two were very similar for the hatchlings. I will take pics and post them :)

Are you straight on the heat source? I was slightly afraid the plastic would get melted, (though it never felt too hot and is somewhat thick).
 
LOL I went to Walmart again last night and picked up 10 of these tubs. We are talking about getting my geckos out of aquariums and putting them into these now.
 
Very cool...I would imagine they would work great for your geckos!!! My first herp was a leapard gecko when I was like...I can't even remember, 16 maybe? He was the shizznit, but at that time I wasn't aware that there were all kinds of cool forums online for him...

And Calift, on ANY kind of UTH you would have to regulate it, with a thermostat, or rheostat (I'm sure you know this already)...Even with a BP where your hot side is like, 93-94 it still won't melt it. I'm sure even with a UTH that is unregulated still wouldn't melt it...

I just did some Googling....ABS Plastic which is what most common, injection-molded plastic items are made of has a melting point of 221 (deg. F)...
 
You must log in or register to reply here.
Back
Top