• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Heating for a snake rack I'm going to build

Scrufdog

Scrufdog

that one guy
I plan on making a front open display shelving rack for my corns and ball python. I'll be using that finished white shelving wood from home depot or lowes. I need to figure out how to heat each individual tank. Do you think an undertank heater would do well to heat through a 1/2 inch piece of wood, or should I consider something else?
 
You could some of those Radiant Heat Panels, that is the only other option I can think of. I've never heated a custom wood cage though, and I've never used RHP's before either.
 
You must log in or register to reply here.
Back
Top