• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Flexwatt Theromostat Probe

knox

knox

New member
The suggested max temp for Flexwatt is 95 degrees.

How many of you place your probe directly on the Flexwatt and keep it at 95 - 97 degrees, as opposed to placing the probe inside the enclosure to ensure a nice 85 degree warm side even if it means the Flexwatt is running at about 105 degrees?
 
I would like to know this as well... For some reason inside my tubs seems warmer than the flexwatt itself...
 
I use flexwatt in my viv and it is covered with plexiglass. The probe in hot glue to the plexiglass above the flexwatt. The temp is mid eighties I would think since there is a slight air gap between them the temp is a little higher.
Is that any help??
 
You must log in or register to reply here.
Back
Top