Cave
Hi, totally new to this site so apologise if similar has been asked before. My son has lovingly made a cave out of air drying clay. If I coat it with a PVA mix as a varnish will it be suitable to use? Thanks in advance
|
I have no idea about your question, but welcome to the forum. Hope someone else knows!
|
Quote:
if the clay is purchesed online or decent stuff for model making it should be fine. you can coat it with pva when i did this i made it for a bearded dragon and sprinkled calci sand onto the pva before it set... but for snakes i wouldnt recommend that. pva will be fine, just dont get it two wet when cleaning as eventually it will wash the pva off, You could use a very low VOC varnish (do a test peice first and make sure it sets) also leave it away from the snake till its 100% cured ;) Hope this helps |
Fab, thank you!
|
All times are GMT -4. The time now is 08:19 PM. |
Powered by vBulletin® Version
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.