View Single Post
Old 08-06-2017, 04:07 PM   #2
Reptile Lover 23
On my corn snake enclosure build, i used a pro rep heat matt on the bottom, with an STC-1000 thermostate to control the temp put the sensor on top of the heat matt,

i have used STC-1000 from ebay there £10.69, i have not had any problems with my snakes, or my hatchlings i even built my incubator using an STC-1000 to control the temp.

my enclosure is 5ftx3ftx1,1/2ft,

Be carful of any sorts of paint, i used acrylic waterbased paint with a low VOC Waterproof sealer.

Hope this help's good look with your build.