Thread: To DIY or not
View Single Post
Old 05-26-2019, 11:34 AM   #8
Maron
It has been a busy week with lots of deliveries.

I now have the case set up with a thermostat and heating mat.

I also added another vent at the top. Both vents have 6mm spaces. Is that something corn snakes will get through as hatchlings? If so I will need to escape proof them or aim to get a bigger snake.

I have put in some decor and substrate with a water bowl so I can get my temperature and humidity settings all worked out before the Kyushu reptile festa this coming saturday.

When I am taking the temp for the hot end, should I be getting my readings from the top of the substrate or from the glass underneath? When the substrate is showing 86 the glass can be as high as 100. I am getting humidity levels of around 70 with the water bowl in there.

Next is to 3d print a few hides I have designed and then all that is left is to head to the reptile show and pick up a snake.