Thread: To DIY or not
View Single Post
Old 05-18-2019, 09:06 AM   #3
Maron
Thanks for the reply.

I just went to my in-laws and found this old display case. Do you think I could fix this up into an enclosure?

It is pretty sturdy and I can add a locking mechanism to the sliding glass doors. If I replace the bottom of the case with 5mm acrylic will that act as a decent enough conduit for the heat from a heat pad?

The space inside the case is 85cm wide, 26cm deep and 45 cm high. Is this enough? Would it be better to it lying down to increase the floor space and reduce the vertical space?

I would also add a couple of vents at each end of the case for ventilation.

Do you think this could work?