• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Cutting Melamine Help...

knox

knox

New member
I have a fine-toothed plywood blade for my circular saw.

I know the best way is to cut it in 2 passes, one half-way, flip, then cut through.

Anyone have success just cutting in one pass? Maybe taping the cut line?

I just don't want a bunch of splintering and gouges in my expensive melamine.

Thanks!
 
You must log in or register to reply here.
Back
Top