• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Mold on my Eggs

JokersWild

New member
I have a reoccurring problem every season. Mold forms on several of my eggs and ultimatly leads to their demise. I use a regular Hova-bator and vermeculite to incubate my eggs. the temperature i set it to is 86 degrees. I have a very low number hatchlings compared to the number of eggs I start out with. I would like to know if there is anyway I can stop this problem, or treat infected eggs so that they live long enough to hatch. Any advise I could get on this matter would be greatly appriciated. Thank You
 
definately get more advice, but I have heard of people using athletes foot powder for similar troubles....

^Curtis
 
For some reason it looks like there is something in or around your home that makes it difficult for you. I'd try a little less moisture and checking on the eggs once a week if you are having trouble. If you catch it soon enough you can get rid of mold by gently dabbing, or wiping it off with a q-tip slightly moistened with listerine, then apply a small amount of foot powder such as desenex. I have never needed more than one or two applications to stop the mold, but if you have past bad mold experiences, you may want to apply weekly. I only get a few eggs with mold each season. In my experience mold on a living egg can usually be controlled. The only time I have not been able to get rid of mold is when it is on an egg I suspected to be dead before the mold got there (like eggs that start to shrivle way before hatching time and when all the others are just fine). Hope this helps, Carol
 
Are you checking the temps in the egg holder? I have heard that the Hovabators have hot spots, and 86 degrees+ could be killing the eggs and then they will start to rot.I did not notice this with mine but I only had one small container and I made sure to put it in the same spot everytime.I had mine set at 82 degrees 5 out of 6 hatched the other was found to be dead in the egg(egg must have rolled) :confused: just a few ideas!
 
Another thing make sure you sterilize everythinhg you are using and dry it thuroly! Mold loves moist dark damp places. And if you dont kill it then it will live on the moisture in the atmostpher till you supply it with more eggs....i hope I make sense.

Sorry I dont spell well
 
Thank You for all of your advise. I will try the listerine and foot powder approach. I will turndown the heat and try switching my nesting materials and I will let you all know how things go for me. Again Thank You for all the tips. If anybody else has anything to add please don't hesitate to write :)
 
It's worth trying a slightly lower temperature - incubation will be longer but you'll be safer. I'm keeping my eggs at 82 degrees to allow my thermostat plenty of room for error. Hatching started at 64 days.

Good luck !
Kel
 
Back
Top