Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.
Registration is FREE, so please register so you can participate instead of remaining a lurker....
Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.
Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.
DIY ProjectsUse this forum to post threads related to home made projects for your corns... Vivariums, hides, decorations, accessories, you name it. Anything to save some bucks or give your personalized touch.
I was wondering, is it possible to put ball pythons and corns in the same rack. Or would that stress the snakes out too much?
I certainly hope it doesnt stress them out too much since I have boas, balls and corns all in my rack! LOL I just keep the balls on the bottom, boas in the middle and corns on the top. I'll try and get a pic this weekend for ya.
Hey, I was just looking at the same rack. How did you score the extra shelving pieces to make it extra deep? The units I was looking at one comes with 1 adjustable shelf.
I get that forsuree! But you have 2 adjustable shelves set up, each adjustable shelf is comprise of 2 seperate shelves. Hence 4 seperate adjustable shelves. The unit I was looking that was the same as yours comes with one 1 shelf each, so that would only be 2 shelves total
It's apparently not the same as mine. The bookshelves if assembled according to normal instructions have 2 movable shelves. So if you have 2 units, then you have 4 movable shelves.
If I were you I would make sure it's the same unit I used...because if so, it will have 2 movable shelves per unit that you buy.
If I did it over again, I would run 11" flexwatt in two strips down the back wall. Back heat = safe. Not that I've had a problem with belly heat...but you can use less flexwatt doing it that way. I used a strip of 4" flexwatt running along the shelf (belly heat) towards the back though..
It will be for 2 snakes not 3 so there will be plenty of room for climbing.I am actually wanting to reuse my UTHs so I was to cut a hole in the shelves in the middle have my step dad hit the hole with a router to give it a lip to hold the glass of course and the UTH on that glass.I would use the other shelf to go beteen the two Vivs to allow for the cord and to let the excess heat build up escape(kind of like the little feet that come with the UTH) then enclose the front with the plexi. for the back I guess I would just use some plywood I have left over from replacing my kitchen floor and add vents Do you think it will work?
I did this today, with 2 of my grandmas book shelves she didnt want, instead of using nails and some wood, i gorilla glue'd the 2 shelves together. It is very steady =D
Join
now to reply to this thread or open new ones
for your questions & comments! Cornsnakes.com
is the largest online community dedicated to cornsnakes . Registration is open to everyone and FREE.
Click Here to Register!