Ghetto Hatchlingt Rack!

Well if ghetto is your thing you nail it!!! But the moisture is a concern in the tubs as stated.

What type of engineer were you for 26 years anyway?

Ya know what? This guy is obviously set in his ways, and nothing is gonna change that; there's really no point going on with this, except to beat a dead horse, belittle, and insult.

Lennycorn said:

Well if ghetto is your thing you nail it!!! But the moisture is a concern in the tubs as stated.

What type of engineer were you for 26 years anyway?

Click to expand...

Hi Lennycorn,

Hey, I said it's ghetto!

To answer your question, I was process engineer, paper mill.

One other list member got the right idea, it's just a seasonal kind of thing.
Probably more important to it all, I have had a lot of experience designing systems. I have found that it is extremely rare to get everything right the first time. Making a cheap, functional prototype is a great option whenever feasible.
I actually made some changes before I put any snakes in this one, the way I was putting the wire behind the tubs first was totally unacceptable, the temps in each tub were markedly different. So I went back to the drawing board and a solution was derived.

To me, the biggest drawback is that it's a little flimsy (lightweight), so I keep it where my kids won't knock it over. But it works the nuts, the temps in each tub are remarkably consistent. Yup, I use a chef's pocket thermometer to check temps, the probe is a perfect length to measure the heat at the point were the heat wire crosses under the tub. One top tub has a thermostat probe to keep temps perfect. It has actually been unplugged for the last few weeks.

The excess moisture in the front of the tubs was just in the beginning, due to water dishes that were too full and spilled too easily. Who knew baby snakes were such little piggies? Once we figured that out, I would only notice a little condensation on the open end if the heat was on. With the back of the box closed, it is very efficient with heat, but only allows for limited ventilation. I think from this I have learned that a winter rack would benefit from ventilation front and back.

I just got a second batch pipping yesterday, so I need to move a couple of the first guys out of the rack to make room!
If I do it again next spring, I may need to build new & bigger.
But it's all good!
Cheers

...

Fyi chefs stopped using those thermometers 5 years ago because they are so inconsistent with temperature and must be calibrated regularly. Besides they are to be used with temps over 100 degrees, they dont even register if the temps are too low...I have been a chef for 15 years and those thermometers are dollar store, like your rack.

With the use of things like !!! and GREAT all the time, its almost like hes amped out on something lol.

Makes me thing of some one Tony the tiger on speed. Just saying lol.

First of all, I like the design, and I think I might make one as a temporary housing when I start breeding.
Then again I do have some concerns.
I think this works perfectly in the few summer months of dry heat, but once winter or humidity rolls around, this may need to be scrapped. I wouldn't be concerned about the cardboard bursting into flames from heat, what I would be concerned about is a spark created by the heating, because, no matter how meticulous you are, Murphy's law is always looming over our shoulder. But as long as there is no more excess humidity in the bins, you should be good for now.
And good job, even with the excess of sarcastic s, you did a pretty good job dealing with a flame war.

Even I can see why this has caused a flame war (yes, pun intended)

Hey yall im havn a really hard time finding the new post button what page is it located

At the top left of the forum you want to start a new post in, is a botton titled New Thread, click on that you Bob's your uncle!