• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Link and Zelda eggs!!

Dahliasmom2012

Dahliasmom2012

New member
abb3c41fdf12b30d8e50254d9d77643c.jpg

My first time breeding. I'm pretty pumped. She laid yesterday and although it looks like a bunch of slugs there seem to be 7 promising eggs.

I'm using Pangea hatch in a Tupperware container. Since I'm going to breed Tanzanite when he's ready to test if he is a super tessera I thought I might iron out any issues I might run into earlier.

Parents are blood red stripe het anery, hypo, amel and 50% het caramel to Amel stripe het anery, blood red, hypo 50% her caramel.



Sent from my iPhone using Tapatalk
 
Most of the eggs didn't look good, cutting showed all dead in egg. I'm sad. I used clay hatchrite and had them in an empty bin in my snake rack at 78 degrees by my temp gun. Something went wrong somewhere. I'll try again but will incubate differently. I'm so bummed out.


Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Back
Top