• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

41Q Rack Working

Thickscaled

Corny Snake woman
So I finally got around to build, or start building, my 41Q rack for when I get my adult snake next week and for when my little yearlings get bigger by end of this year/early next. I plan on buying another 4x8 melamine board with my next check which will finish this 5ft rack up. Going to be adding some glued sides to the edges because I don't quite trust it.

Anywho I think this is looking great for my first ever rack build... let alone my first ever big project.. I don't build much just duct tape around. Let me know what you think. The tubs are 41Q's I got from Walmart.

I also learned a couple lessons the hard way. 1) If you have to move it from one end of the house to the room... wheels and 2) Don't hammer... (gonna break down and get a drill/driver before I put the next set on)

Like I said its a WIP but I wanted to share it as I'm pretty proud =D, I'll upload more when it's fully done. I've got heat tape to heat it but it's not on the rack yet.

sl4nsz.jpg
 
Back
Top