• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

humidity?

bullfrog

New member
Hey guys i was wondering what is a good humidity to kep my eggs? I noticed that a few of them feel like there is rubber in them and are pretty yellow. Also some have half of the egg like this. Are the ones that look like this gone? Thanks. BTW- i tried kicking up the humidity by spraying the vermiculite with a reptile mister but it doenst seem to work. It just stays at around 80-85.
 
The manual says that a good level of humidity is close to but not quite 100%. If you're having problems with your vermiculite, pour a little water around the edges of the tub/incubator they are in and keep them covered with a paper towel.
 
Back
Top