• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Krylon paint OK?

Cane

Cane

New member
I'm pretty sure it would be reptile safe for painting the inside of a vivarium for my Shesha but I was wondering if anyone has found information to the contrary. Any other surface coatings that would be moisture proof enough to use on plywood?
 
I built several enclosures for reptiles using hardboard thrifty white tile board that comes in a 4 X 8 sheet at Home Depot. It is prefinished in acrylic white and can be glued to plywood with liquid nails or other panel adhesives. They even cut mine to size for free. I did seal the joints with sink & tub silicone so it was waterproof. I used heat lamps for lizards that required them and the heat never affected the coating.
 
You must log in or register to reply here.
Back
Top