Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.
Registration is FREE, so please register so you can participate instead of remaining a lurker....
Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.
Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.
DIY ProjectsUse this forum to post threads related to home made projects for your corns... Vivariums, hides, decorations, accessories, you name it. Anything to save some bucks or give your personalized touch.
Well, I am soooooooooo close to being done. The only thing that is left to do is to put in the heat pads and seal down the glass which Im going to use hot glue because the UTHs wont get hot enough to liquify the glue and later when I get Heat tape I can put in exact same size heat tape and run a thermostat to keep both chambers at the same temps (or close to it). The BP will end up in the top one since they seem to like slightly higher temps. If you notice on the back of the top chamber there is a piece of plexi covering a good part of the plexi for the top chamber, that is to keep the humidity at a decent level but at the same time allow air to circulate.
O and by the way, the door seals great right at the second shelf so the BP should not be able to get in with the corn or the corn in with the bp.....just thought I would mention that cause its kind of hard to tell in the pictures.
Join
now to reply to this thread or open new ones
for your questions & comments! Cornsnakes.com
is the largest online community dedicated to cornsnakes . Registration is open to everyone and FREE.
Click Here to Register!
I am soooooooooo close to being done. The only thing that is left to do is to put in the heat pads and seal down the glass which Im going to use hot glue because the UTHs wont get hot enough to liquify the glue and later when I get Heat tape I can put in exact same size heat tape and run a thermostat to keep both chambers at the same temps (or close to it). The BP will end up in the top one since they seem to like slightly higher temps. If you notice on the back of the top chamber there is a piece of plexi covering a good part of the plexi for the top chamber, that is to keep the humidity at a decent level but at the same time allow air to circulate. 
Linear Mode
