• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Cable access

S

ShaolinDan

New member
Are there cable access ports available that I can add to a wooden Viv so that I can feed a plug from a heat mat and a thermostat probe through?


Thanks.


Sent from my iPhone using Tapatalk
 
We have many options here for allowing probes or cord access through wooden sides or bottoms. I have drilled holes and used rubber grommets to seal around the cord and hole. But you need to research what is available in your area. Sometimes a computer shop, or electronics store has something that will work.
 
You must log in or register to reply here.
Back
Top