• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

plexiglass

A

absolutneil

New member
I was at a show back in December and I met with Don Soderberg of South Mountain Reptiles. He has built a few cages from plexiglass.

Does anyone know how this is done? How do you affix the plexiglass pieces? Plans?...
 
I'd like to know too. I think it is glued/epoxyed (sp) together. I've seen plexiglass at Home Depot and was wondering if they will cut it for you or if it can be cut easily.
 
I imagine HD will cut it for you, but even if they don't, it's pretty easy to cut. You can do it with a stout-bladed carpet knife (aka utility knife) and a straightedge (the ruler, not the punk...). Just score the same line a few times (sometimes you need to do the front and back), put it over the side of a table or countertop, and snap it off. That generally works pretty well.
 
then seal it together with aquarium sealant,just the same.as build a fishtank.hope it helps.
 
You must log in or register to reply here.
Back
Top