• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Recent content by juncohorse

  1. J

    looking for some uth info

    Does anyone have any experience using a peel and stick uth on 3/8" thick glass? Most consumer vivs or aquariums are only 1/4" thick. Also, those of you who use the heater in the tank with a ceramic tile, do you peel and stick it to the bottom of the tile or just lay the tile over top of it...
  2. J

    in blue and feeding question

    Hey all If my snake is in blue when the regular feeding day comes around, is it better to offer the food and let the snake choose to refuse it or just skip the feeding all together? Thanks in advance for your opinions.
  3. J

    thanks for a great site

    Hello everyone, Figured I would post a belated intro(registered last month). I mainly lurk around the site and use it as a 'living' reference book so I wanted to say thanks for all the info I have acquired here. Below is Chevron who I got from VMS Herps back in March. She has adjusted to her new...
  4. J

    UTH - Thermostat question

    I'm using a UTH mounted to the bottom of my enclosure run through a thermostat controller. My question is where should the probe go. I use aspen bedding (about and 1 1/2" or so). I understand that the warm side should run about 85 degrees. If my probe sits on top of the bedding to maintain 85...
See more
Back
Top