• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Any suggestions

H

Hethiss

New member
On my Exo Terra Terrarium at the back on top there is a small gap that runs between entrys for wire. Hethiss has decide to squeeze himself in there when he was younger now he is bigger he is squishing himself in. Any suggestions on the best way to stop him going in there
 
You could fill the area with a hot glue gun. Well, the glue from the gun. Not the gun itself haha. I wouldn't use tape. That could be a sticky and painful situation for your snake.
 
I agree with the hot glue. As long as it is not that big of an opening, you should be able to hot glue it shut with no problem and its completly safe for the snake
 
Thanks for the advice. For now i am going to use a piece of cardboard tube folded up or a piece of cloth.
 
BluTak can be shaped to fit and won't stick to the snake. I always use it to seal gaps round wires - works a treat.
 
You must log in or register to reply here.
Back
Top