• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Ball Python Winter Heating Help

B

blackorchid77

New member
Ok

I have a UTH on him right now, since its a bit cooler these days.. in summer I didnt use one because it was steaming hot in my apartment. OK so I just got a new red bulb to use in my heat lamp (for the winter). So which side to I put it the lamp on? Do i put it above where the UTH is or on the other side? If it helps my apartment in the winter is very cold.

thanks
 
I would watch your temps close but put the red bulb above the side the uth is not on. Also, if your apartment is that cold I would just plug the uth in and not use a thermostat or rheostat. Again, watch your temps close though. You may have to fiddle with placement of the red bulb to keep a cool side and a hot side that is acceptable too.
 
Also, make sure your bedding is thick enough if you are just going to plug the uth in without controling output.
 
You must log in or register to reply here.
Back
Top