• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Getting Sterilite Ready

Messorius

Messorius

New member
I drilled holes into my tub tonight(and did a tidy job, if I do say so myself) but I've got some rough edges left I'd like to get rid of around the holes, without scratching the beans out of the plastic. Anyone have a good method for doing this? Thanks!
 
I use a soldering/wood burning tool. It is long and pointed. It heats up and just melts a little hole (about 1/4 cm or less) in the plastic. The holes come out nice and smooth---be careful to do this in a well-ventilated area.
 
You must log in or register to reply here.
Back
Top