• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Shedding in bits

Plumcrazee

New member
Hi guys my mate has a corn snake given him about 4 weeks ago and it's just shed for his first time but it's coming of in bits

Here is a pic

hyra8enu.jpg


Is there a reason for this and can he do anything to help like giving it a bath???


Matt
 
You can try what's called "soaking" where you put the snake in a tub of slightly cool water (should be about 75F, but feels a little cool to us) for about 20 mins; just enough to cover the bottom but not enough to make the snake swim.
You can also get a damp towel and have the snake slither through it in your hands several times.

The reason it is coming off in bits is because the humidity is too low. While in shed, the humidity should be bumped to about 50%. If you/your friend is unsure of the humidity, they should have a hygrometer to measure.

For future reference, damp sphagnum moss hide works well during shed cycles :) or misting the tank lightly daily.
 
NH93 is pretty much dead on, especially with the damp towel to get the stuck shed off. Most corns don't have a problem with humidity - are you using an overheat heat lamp at all? Those can dry out the air pretty terribly. If so, I'd recommend switching to an under tank heater regulated by a thermostat. You can also add in a humid hide; I use one for my leopard gecko and it's just a tupperware container with a hole cut in it stuffed with damp sphagnum moss.
 
Back
Top