• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Tank heat?

redneck

redneck

Mmmm BEER.
So when i set my tank heat is it suppose to be on the glass with a uth or in the bedding or on top? the air temp during the day with my lamp is 85 on the hot side and 72 on the cool. at night the cool side gets to 68 to 71 depending on the house temp. Am i doing it right? any advise would be great
 
Well, if you are using a lamp then you should measure the temp at substrate level. No reason to measure under the substrate if you aren't using a UTH.
 
If you're gonna use a UTH it should be on the glass on top of where the UTH is stuck. Thats the way I understand it, hopefully someone with more experience can confirm that:)
 
hunter you little thread hi-jacker you.lol
very nice snake:)
Why dont you start a new thread to ask all your questions? Everyone on this site is really helpful and they've helped me alot everytime I've asked anything.

Good luck with your new snake:) and congrats
 
You must log in or register to reply here.
Back
Top