• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Cleaning?

I always thought it was 3% mix bleach/water solution? I guess it probably has a range like anything else.
 
I am sure as long as you rinse the viv very thoroughly and dry it good, 3% or 10% solution, all will be ok. I use 1/2 cup bleach per gallon of water to clean the viv. That is a 3% solution. I have had no problems at all. :cheers:
 
Do you just empty out any substrate and then wipe down the viv with a wet paper towel dipped in the solution? Is it a good idea to rinse? Do you use the solution on the water bowl?
 
I think most people like to get rid of all their substrate and start fresh. I believe they completely water down the whole tank and make sure it is absolutely clean. It's all up to you though.
 
Yes. I generally scrub them in hot water and if there's any poop on there with either a mild soap or chlorhex and rinse well.
 
You must log in or register to reply here.
Back
Top