• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

covering the whole.....

brtrude

brtrude

New member
Hi everyone.
Has anyone got any good ideas how i could cover up a little slit in the mesh on the top of my glass tank. Its only small but im sure a determined corn could escape through it.
Its not a problem at the min because the is a heat lamp attachment filling it in (no bulb attached) but i dont want that there forever because to be honest it looks pretty ugly.

Any ideas would be appreciated.
Thanks
 
ooooo thanks for the linc that was good. I was wondering though, theres a bit were it says you can repair small holes, 1/3 of an inch with glue. Would this be ok to just get it coverd and sorted? Would it be safe for the snake to use glue to fix it??
 
You must log in or register to reply here.
Back
Top