• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Custom Viv build

D

dmayer5

New member
I am almost done with the custom build but here is the work in progress! Still have some touch ups to do on the exterior.

1.JPG

2.JPG

3.JPG

4.JPG

5.JPG

6.JPG
 
It looks similar to something I was thinking of making. I was going to leave spaces below each section so that I could put heat tape on a removable board or tile that I could just slide in and out of the space. I wanted it to be easy to remove in cause something happened and I needed to replace it.
 
That's awesome! Pegboard definitely worked out better than trying to cut out circular vents.
 
Thanks everyone for the comments. I. Do plan on writing up a synopsis of the build, hopefully this weekend, and yes solo the peg board worked perfect. Thank you for the suggestion!!
 
You must log in or register to reply here.
Back
Top