• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

DIY: 4 Unit Vivarium out of kitchen pantry...

Sorry its taken so long, but here is the finished product in its place...


6369_1154202340181_1381370960_30645388_7705219_n.jpg


6369_1154192099925_1381370960_30645300_3188454_n.jpg


The lights I only put on to photograph cause like I said they get HOT FAST, I dont even have the heat pads on right now. Anyway, since we went with the thicker plexi we have been escape proof and everyone is doing nicely.
 
Looks Great!! Is it easy to clean out?? Does much of the Aspen end up falling through the bottom peg holes behind the unit??
 
Asbit said:
Looks Great!! Is it easy to clean out?? Does much of the Aspen end up falling through the bottom peg holes behind the unit??
Click to expand...



It is pretty easy. I spot clean a few times and then change all the aspen when it needs it, and so far its been the same as cleaning the tanks I used to house them in.

I use that healthy habitat reptile cleaner spray, and wipe everything clean.

I havent had any aspen fall out the back. The pegboard holes are really small, even smaller once you coat and waterseal it, to get aspen out of the back, youd have to pick some up and shove them out the holes with your hand....plus where the pegboard meets the acrylic, its siliconed.

Only problem I have run into is, I wish I wouldve attached some sort of knob to the plexi, because even after I open the latches, I have to pry the acrylic open, its tight in there....its good to prevent escapes, but a pain for me when I need to give someone fresh water.
 
Again Great work...May just have to commission my resident carpenter to start a building project for me!!:idea::laugh:
 
You must log in or register to reply here.
Back
Top