• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

flexwatt question

gimpsnakelvr

gimpsnakelvr

New member
so my cage for my bp came the other day and i just put it together last night. i'm using flexwatt and was wonderin if i need to put some spacers on the cage bottom to give the bottom of the cage and flexwatt some breathing room? my first cage the flexxwatt was built in, this one its just taped on the bottom outside.
 
gimpsnakelvr said:
so my cage for my bp came the other day and i just put it together last night. i'm using flexwatt and was wonderin if i need to put some spacers on the cage bottom to give the bottom of the cage and flexwatt some breathing room? my first cage the flexxwatt was built in, this one its just taped on the bottom outside.
Click to expand...

I use flexwatt on all my racks and tape it directly to the shelves and sit the tubs right on top. It probably wouldn't hurt to give it some breathing room but more importantly use a rheostat or thermostat to regulate the heat.
 
dwyn127 said:
I use flexwatt on all my racks and tape it directly to the shelves and sit the tubs right on top. It probably wouldn't hurt to give it some breathing room but more importantly use a rheostat or thermostat to regulate the heat.
Click to expand...

yea i use the herpstat from spyder robotics. i was just curious if having the flex touching the table is hazardous? i read about uth's needing space for circulating
 
Can someone explain to me how flexwatt works? Is it just hot tape that wears out after a while and needs to be replaced, or does it need to be plugged in, or what?
 
is there a op or bottom for flex? the stuff i got didn't say, but it seems to only be 84ish after 24 hours plugged in.
 
You must log in or register to reply here.
Back
Top