• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Heat Mat Recommendation?

S

Skittles2u

New member
If you only had 6 snakes, would you buy individual heat mats for each or would you make one with the heat flex? (they have heat now) I'm just trying to look at more uniform housing for them and trying to decide if I should build a rack type set up; or just use individual sterilite containers, and trying to figure out about the heat mats.
 
I would say go for the Flexwatt heat tape. For 6 snakes, it would be more expensive to use heat mats for every single one.

Would you rather build a rack or multiple cages of which you can easily see inside? Below is a pic of a four-viv high enclosure that I built (will fit four adult corn snakes for their entire life) that was only $190. For heating, I used Flexwatt heat tape purchased from The Bean Farm (very good prices!).

127380276-M.jpg


Lisa
 
You must log in or register to reply here.
Back
Top