• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Help with Zoo Med thermostat

CallmeMacc

CallmeMacc

New member
Its the ReptiTemp 500r i'm having a really hard time getting the right temperature i think i have it after an hr its at like 84-88 then I come back a couple hrs later and its at 97 degrees i don't get it. does anybody have any experience with this or other thermostats that you recommend...... btw I have a uth connected to it
 
Put the thermostat probe and the thermometer probe in the viv, in the center of the UTH, directly on the glass.

Then, start with the thermostat at its lowest setting, and gradually increase the temp, only a couple degrees at a time, giving it an hour or two in between to stabilize.
 
You must log in or register to reply here.
Back
Top