• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

looking for a rating on this screen

only problem i see is that it has no visible lock or anything holding it there. or am i just not seeing it. i think some species would be able to slide it easily off if thats the case. other than that thats an awesome design for a lot of animals at the same time.
 
i was looking at that too and i was thinkng maybe i can buy some clips and put them on the front where it slides out
 
dont know if your handy at all. but theres this link that might of help. http://www.cornsnakes.com/forums/showthread.php?t=72848
you could go with something like that and custom it to be sliding. i wish i did a diy when i helped my buddy make sliding screen tops on 55g tanks. we just made a small frame and stapled it together with the screen smashed inbetween the 2 frames of wood. it was like a 1/4" thick. then we fastened a ledge higher up and a overhanging lip. the screen slid in and there was 2 pieces of 1/4" wood on the front corners that were screwed in so they could rotate. and thats what held the screen from sliding back out with snakes in the tanks.
 
You must log in or register to reply here.
Back
Top