• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

made new incubator. woot!

tsuki

tsuki

snake charmer
so i had some time off today and put it to use. i got a new styro cooler because my old one was too big. and i used my existing parts: 8w heat mat, thermostat, digital temp guage.

its in the process of getting to temp right now so i can dial in how warm it needs to be.

what you think?
042110145602.jpeg

042110145806.jpeg

042110145838.jpeg

i gave it a neat look because its going to stay in my room in sight so i wanted it as clean looking as possible.
 
Sweeeeet! Coolers are good. They keep great temps. The only suggestion I would give would be to use multiple thermometers to check all the temps. Top, Middle and the bottom.

Wayne
 
You must log in or register to reply here.
Back
Top