• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Multi-Unit Display Cage Heating Question

CandyCorn88

CandyCorn88

New member
My husband is going to make me a multi-unit display case, bookshelf type design, and we are wondering what is the best way to heat each unit. We were thinking heat tape, but does it go inside the individual units covered with something or should the heat tape go on the back of each unit? Which would be better? Since there is not going to be any empty space between each shelf the heat source will not be able to go under the units without affecting the unit under it, we know this much. Any advice would be greatly appreciated!
 
11" flexwatt with the connections sealed with silicone and then a piece of plexiglass on top and that sealed up as well so that its effectively been water proofed.
 
You must log in or register to reply here.
Back
Top