I'm not too hot at posting. I'm more of a reader than a writer but I thought I would get opinions on this. I made this rack in anticipation of getting into cornsnakes, although now I'm eyeing milksnakes so I'm still undecided but it should work for either if I did everything correctly.
I used 2 pieces of 2'x3' melamine and 3 pieces of 2 x 4 melamine, 1 precut 2'x3'sheet of pegboard, 8' of flexwatt, and 15 qt. and 32 qt. rubbermade locking tubs. Here is what it looks like so far but I'm not quite done.
The tubs were bigger than the shelves so I made a little extra room in the back so they wouldn't stick out in the front.
Here is how I did the flexwatt. Each shelf is wired separately so I can turn them on as I fill them up.
Here is a shot with my other two cages.
And here are the occupants, Koin and Kiri.
I have a Herpstat on the way for temperature control but I'm not sure how to figure out how many holes and where to put them in the tubs. Thanks.
I used 2 pieces of 2'x3' melamine and 3 pieces of 2 x 4 melamine, 1 precut 2'x3'sheet of pegboard, 8' of flexwatt, and 15 qt. and 32 qt. rubbermade locking tubs. Here is what it looks like so far but I'm not quite done.
The tubs were bigger than the shelves so I made a little extra room in the back so they wouldn't stick out in the front.
Here is how I did the flexwatt. Each shelf is wired separately so I can turn them on as I fill them up.
Here is a shot with my other two cages.
And here are the occupants, Koin and Kiri.
I have a Herpstat on the way for temperature control but I'm not sure how to figure out how many holes and where to put them in the tubs. Thanks.
