• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

New boa cage

Carinata

Carinata

Ever Evolving Exotics
Okay here it goes It has an UT heater and I'm gettin the drill to put the holes in tomarrow how many should i put
The cage is a 27qt. sterilite
2 hides
large water dish
deer antler to climb on
I will be adding stuff next time I got to the pet shop
I put in the Thermomater and the humidity gauge after I took the pics

017-1.jpg

016-2.jpg

015-3.jpg

014-1.jpg
 
The amount of holes will depend on a couple of things.... What temps are being reached in the rub, the humidity in the rub and how much ventilation you need.....
These are things you have to suck it and see ...IMO
One good tip though.....
You want hole/holes at the bottom at one end and 4 times as many at the top on the opposite side..... This will start a convection current and cause the air in the rub to be replaced with fresh air..... Remember the 4:1 ratio is important.....
 
You must log in or register to reply here.
Back
Top