• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

New hatchling rack

BigBass10

BigBass10

New member
Here are some pics of my hatchling rack that I built this year and a couple other pics from the snake room
IMG_2012082331128.jpg

IMG_2012082349191.jpg

IMG_201208236603.jpg
 
Awesome! When I first looked at the first pic I thought the rack was MUCH BIGGER then it actually was, until I saw it sitting on the table. Then I saw the proper size lol.
What did you do for heating? Flexwatt? Where did you put it?
 
Heat pads for now until I get 17 inch flexwatt. I put it in as back heat. I am normally a fan of belly heat but that was not feasible here. The deli cups are small enough that back heat I think is sufficiant.
 
How did you interconnect the shelves? Cut halfway into each piece then put them together, I can't remember the proper term right now... Lol.
 
you just used a 1/4" dado blade? sounds awesome, it's a great idea for a big hatchling rack. I'll have to make something for about 3-4 years down the road.
 
You must log in or register to reply here.
Back
Top