• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Reminder to Check Flexwatt Sometimes

ascottlaw

ascottlaw

New member
Tonight I found that a section of flexwatt had overheated and melted a hole in one of my bins. No harm to the snake and only a little heat damage to the rack, but it got very hot. From the heat mark it looks like a small patch of element about 2 inches in diameter overheated. All the other bins on the rack were still at their normal temps. Just thought I'd pass this along as a reminder to inspect your heat sources every once in a while.
 
The rack is thermostat controlled, but on a different bin. My problem was a very small short of some kind.
 
You must log in or register to reply here.
Back
Top