hi, my new corn just shed for the first time since ive had it, its roughly 1 month and a half old. ive had for 4 weeks, i knew it was ready to shed and sure enuf yesterday morning i woke up and tere was the shed lying there, well most of it, trouble is it was on the whole one bg shed but there were some scattered parts, and some of it is still on the snake, is there anything i can do to help with wot is left?
-
Hello!
Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.
Registration is FREE, so please register so you can participate instead of remaining a lurker....
Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.
Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.
shedding
- Thread starter tribal
- Start date
Neil
Senior Member
Yep, if your snake is prone to bad or flaky sheds then there are a few things you can do.
- You can bathe your snake in room temperature water for ten minutes or so. This helps loosen the skin.
- You can lightly spray the viv with cool water a couple of times a day during the shedding process. This increases the humidity and aids shedding.
- Also, there are products you can buy which you rub onto the snake to loosen the skin.
[/list=1]