• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Super excited!

josie

josie

New member
I am super excited. I picked up a rack for my corn hatchlings today at the reptile show in Cleveland. I am picking up a thermostat tomorrow and getting air holes drilled in the tubs and it should be ready for my little ones to move in by this weekend.....Just in time for my new additions! I am the proud new owner of a male butter stripe and a caramel stripe 100% het butter female. They are related to my male butter and my female caramel 66% het stripe. I will be picking them up this week.

Thanks Dan :)
 
Congrats fellow Cantonian. I was at the Cleveland show today as well. Were they the black racks that had the heat tape installed?
 
Yes they were. There were three of them, I bought the smallest. There are 12 tubs. Leaves me more room to grow. LOL

Seijin said:
Congrats fellow Cantonian. I was at the Cleveland show today as well. Were they the black racks that had the heat tape installed?
Click to expand...
 
Air holes are a real good idea, I would use a soldering gun to poke holes in the tubes cause sometimes a drill will crack the tubs.
John
 
zorro said:
Air holes are a real good idea, I would use a soldering gun to poke holes in the tubes cause sometimes a drill will crack the tubs.
John
Click to expand...

yep,

I would agree!! learned that the hard way...Soldering iron is the way to go!! you can get them at radio shack for Cheap!
 
Some have air holes but we planned on putting air holes in the rest. Same size I'm using in their vivs now. I picked up the thermostat today so I will be setting the rack up tomorrow after school and adjusting the heat.
 
You must log in or register to reply here.
Back
Top