• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Trouble with heat/humidity...!

The tank should be lifted off slightly off of whatever surface you have it on, because you don't want to crack the glass anyway.
So when the tank is lifted up you can affix it to the heat mat.
 
Corny Noob said:
The tank should be lifted off slightly off of whatever surface you have it on, because you don't want to crack the glass anyway.
So when the tank is lifted up you can affix it to the heat mat.
Click to expand...

Aye, it's lifted off the table with polystyrene. Not being funny, but can't you see that in the pic? (It did work - right?) :)
 
Well then you need to trim what you have under the tank so that it's not covering the whole heater.
Simple solution :shrugs:
 
You must log in or register to reply here.
Back
Top