• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Using leaves

Asphalt_World

New member
Do people who use leaves simply gather them, clean them and cook them a little on the oven to kill off potential bugs? Are there leaves (in the UK) to be avoided?

Thanks all.
 
I tried using cypress leaves from a cypress tree in our back yard a few months ago. I wanted to use them for my Everglades Rat Snakes, because I am doing swamp-themed vivariums for them. In the end, I changed my mind because these particular snakes are Scaleless and cypress leaves are a bit "prickly". However, the method I used was:

(1)gather fallen leaves and soak them overnight in a bleach/ water solution of 1 gallon of water to a cup of bleach overnight.
(2)soak a second night in plain water.
(3)squeeze out as much water as possible and place on a tray and place in oven on low heat until the leaves were dry.

I didn't have any problems with bugs, but it seemed (to me) that the snakes were less inclined to burrow, and I assumed it was due to the afore mentioned "prickliness".

Best of luck!
~Beau
 
Back
Top