• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Wire for Vivs?

Jrgh17

Jrgh17

Are we there yet?
Aside from the obvious sharp edges and such, is there any type of hanging wire or similar that isn't okay to use in the Viv? For instance, any metals that cause problems? I'm thinking of using some of the braided picture hanging wire to hang stuff, and want to know if it'll cause any problems.

Thanks!
 
I would avoid any type of metal wire that tarnishes or rusts, as this would indicate that a chemical reaction has occurred--and I wouldn't take any chances with this coming into contact with a snake (even though down here in the south, corns are drawn to metals because of there ability to heat up from the sun--see the book Herping the Carolina Tin Fields).

I would also be concerned about the potential for a snake being pinched by the braided wire you referred to.

If I was to hang anything in a viv, I would go with something like a sisal or hemp rope/twine. I think this would be safer, less expensive, easier to replace, and more natural looking.
 
You must log in or register to reply here.
Back
Top