• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

ATTN: Heat for hatchling rack?

JAG 32

JAG 32

look at that face :)
I'm getting into breeding next year and i was wondering what i should use for heat. I'm going to have a hatchling rack. What type of heat source should i use for it. Any help will be appreiciated. Thanks
 
Use the electric heat tape type stuff that you can buy at a local hardware store with a thermostat. Don't put it under your cages, sliding them out will wear down the heat tape. Don't put it over for the same reasons and more. Behind the containers would be your best bet.
 
I was thinking about building a bigger hatchling rack with Flexwatt heat tape.
And put the heat tape under the boxes.
Is sliding the boxes over it realy bad?

Here mine currect hatchling rack with only space for 36 hatchlings, which was ok for the first two years,
but next year I have 6 females ready for breeding.
I use heating wire for this one, but the source no longer have them.
creche1.jpg
 
You must log in or register to reply here.
Back
Top