Im still trying to figure out how to heat this rack. If i put the tape under the tubs then the tubs dont slide well (or not at all really)
So im wondering if I can do back heat like pictured. It would obviously be attached better then it is there, it was just thrown on there quick for the pic.
Im just not sure about this way because theres no back to the rack so im not sure that will work.
If it would work then my next question will be about attaching it.. would i be able to put nails through the clear part above and below the copper strip to attach it at each end?
Really trying not to scrap this rack and start over
So im wondering if I can do back heat like pictured. It would obviously be attached better then it is there, it was just thrown on there quick for the pic.
Im just not sure about this way because theres no back to the rack so im not sure that will work.
If it would work then my next question will be about attaching it.. would i be able to put nails through the clear part above and below the copper strip to attach it at each end?
Really trying not to scrap this rack and start over

