• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Im gana be a daddy!!

dbinder1987 said:
So the female is in her own tank now, i should try to get her to eat tomorow right? should i try the f/t mice that i usually feed them? or should i get like hoppers or something a little smaller?
Click to expand...
Mine actually preferred large pinky mice ( after they lay) their easier to swallow and digest, she is probably exhausted. I also use a syringe ( no needle) to give them water. Have you held her up to a bowl of water yet? Also do you have a hide for them both? Usually they lay in their hide. I really hope that you choose to house them separately in the future.
BEST of luck!
 
Given that these are his rescue previously-cohabbed creamsickles, I think he's doing a really good job adjusting his husbandry to do what's best for them. Let us know how the eggs do!
 
Regarding incubation, I've successfully hatched a clutch in a homemade incubator constructed as follows...

Get a styrofoam (spelling?) container with top, an aquarium heater, a tupperware container large enough to hold the eggs and some vermiculite, and a brick.

Fill the styrofoam container with a couple of inches of water. Put the aquarium heater down in the water. Put a brick in the bottom of the styrofoam container and set the tupperware container with moistened vermiculite on top of the brick. Punch holes in the top of the tupperware container for air exchange. Lay the top of the styrofoam container on top, but leave it off center about an inch (also for air exchange). You can also make the gap bigger to help regulate the temp. Adjust setting on aquarium heater so that temp in the tupperware container maintains appropriate incubation temp. Make sure condensation from tupperware top is not dripping on eggs.
 
You must log in or register to reply here.
Back
Top