• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Lost Snake

crittercagesij3.jpg


This looks a lot like what I have. Perhaps I should give it a second chance? If I do, Ill try the paperclip through that locking hole. (I will use a nail though) Im going to keep painter tapeing her in for now.
 
That's what's on all mine. I slide the lid in, wiggle it side to side to make sure it's in the tracks, click the latch, then pull back to make sure it's locked.

Wouldn't you have seen if yours was slid back???

Nanci
 
I would think so but then, How did she get out. If it wasnt closed, the hole would have been very small but as I understand it, thats all that is needed. She is 33 inches long right now...not too think so..
 
You must log in or register to reply here.
Back
Top